Hamilton Beach HBF400 Manuel d'utilisateur télécharger pdf (Page 11)

Problem . . . Solution . . .

Ingredients will not mix

properly

• Check to see if enough liquid has been added to the ingredients. Mixture should

be fluid and free-running at all times.

• Solid pieces are too large.

• Container is too full. Do not fill past highest graduation marking.

• Cutter assembly blades are not sharp or are damaged. Inspect container and

cutter assembly daily. Replace cutter assembly at least yearly or sooner if cutter

assembly appears worn or damaged.

• Check to see if cutter assembly is installed properly.

• Select speed to create a fluid blend.

Troubleshooting Guide

Blender fails to start

or stops while it is

running.

• Check to see if unit is securely plugged into an electric outlet of the proper

voltage and frequency.

• Check to see if the fuse for the electric outlet has blown or if a circuit breaker

has tripped.

• Check the integrated circuit breaker on the bottom of the blender base. If it trips

again immediately or frequently, contact Technical Service.

• Thermal overload protection has been tripped. Allow unit to cool.

• The motor is overheating. Try mixing smaller batches or running for shorter cycle

times. Allow motor to cool between batches.

Unplug the blender and remove the container from the base, and then inspect the

container and cutter assembly for wear, nicks, and broken or loose blades. Replace if

necessary. If the blades are loose, discontinue use immediately and replace the blades.

Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts”.

Unplug the blender, and then inspect the power cord insulation and power plug for cracks.

Refer to “Technical Service” for repair or replacement. Remove container from blender

base. Inspect the cutter assembly by rotating the drive end of the cutter assembly by hand.

It should turn smoothly. If it does not, replace the cutter assembly. See “Replacing the

Cutter Assembly” for details.

Inspect the blender and its various parts and replace as follows:

Daily

Weekly

Maintenance

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Pas de commentaire

Hamilton Beach HBF400 Manuel d'utilisateur Page 11